Welcome, Guest. Please login or register.

Login with username, password and session length




Total Carlton > Carlton Technical > Bodywork > Door lock barrel swap.
Pages: [1]   Go Down
« previous next »
Print
Author Topic: Door lock barrel swap.  (Read 302 times)
0 Members and 2 Guests are viewing this topic.
Tetleysmooth
Global Moderator
Wanted: Life
*****
Posts: 2893
« on: December 15, 2006, 03:31:10 AM »
Is it possible to put a door lock barrel from the passenger side door into the drivers door?
If so, is it an easy job, or can I expect lots of little bits to fall out once the circlip is removed and the barrel is pulled out?
Logged
Nils desparandum illegitimi carborundum.
bstardchild
Wanted: Life
******
Posts: 2638
« Reply #1 on: December 15, 2006, 09:19:01 AM »
Quote from: Tetleysmooth on December 15, 2006, 03:31:10 AM
Is it possible to put a door lock barrel from the passenger side door into the drivers door?
If so, is it an easy job, or can I expect lots of little bits to fall out once the circlip is removed and the barrel is pulled out?

Provded the key stays in it - no bits will fall out
Logged
Cheers

BC

"The Lotus Carlton is not tail happy – honestly -  as long as you accept it has 377 bhp and 419 lb/ft of torque, is rear drive and has no driver aids, it's fine."
Tetleysmooth
Global Moderator
Wanted: Life
*****
Posts: 2893
« Reply #2 on: December 15, 2006, 11:27:05 AM »
Thanks BC, that sounds reasonably straightforward.
Logged
Nils desparandum illegitimi carborundum.
Pages: [1]   Go Up
Print
« previous next »
 
Jump to:  

Valid XHTML 1.0! Powered by SMF 1.1.16 | SMF © 2011, Simple Machines | Locale by Crip Valid CSS!