Welcome, Guest. Please login or register.

Login with username, password and session length




Total Carlton > Carlton Technical > Sparky Bits > ABS sensors & rotors.
Pages: [1]   Go Down
« previous next »
Print
Author Topic: ABS sensors & rotors.  (Read 340 times)
0 Members and 2 Guests are viewing this topic.
Tetleysmooth
Global Moderator
Wanted: Life
*****
Posts: 2893
« on: June 14, 2006, 10:48:51 AM »
I'm sure this subject has been dealt with before, but what's the best way of removing & cleaning the ABS sensors and rotors?
Logged
Nils desparandum illegitimi carborundum.
carlton_mad
3.0 CDX and now Diamond 3.0 24v
Administrator
Wanted: Life
*****
Posts: 5217


dartford kent
« Reply #1 on: June 14, 2006, 08:42:46 PM »
dont remove them dave just give the rotors a good wire brushing
Logged
what would life be like if we all drove fwd cars? feckin boring that's what rear drive or bust
Tetleysmooth
Global Moderator
Wanted: Life
*****
Posts: 2893
« Reply #2 on: June 15, 2006, 02:26:52 PM »
While I was replacing the front discs & pads, I put a piece of sandpaper up against the rotors and kept spinning the hubs backwards and forwards, the I sprayed the whole lot with electrical contact cleaner. The ABS light now goes straight out. Result  Cheesy I didn't get the sandpaper anywhere near the end of the sensors though as I think they're a bit sensitive.
Logged
Nils desparandum illegitimi carborundum.
Pages: [1]   Go Up
Print
« previous next »
 
Jump to:  

Valid XHTML 1.0! Powered by SMF 1.1.16 | SMF © 2011, Simple Machines | Locale by Crip Valid CSS!